Manual

Cross bearing

Combine two or more bearings to narrow down a position. Use map bearings or LiveView bearings, then calculate and save the intersection points.

Manual

Guided two-position cross bearing

The direct Tools workflow complements intersections calculated later from stored objects.

Measure A and B

Save bearing A as a draft, move far enough sideways and measure the same target from position B.

Evaluate quality

Nearly parallel lines, a short baseline, an intersection behind a bearing, poor sensors or a very distant result trigger warnings. Repeat B or discard the draft when necessary.

Place at least two bearings from different locations. Clear crossing angles give more reliable results.

Workflow

First bearing saved

Move to a second position and measure the second bearing.

  1. Bearing ASave bearing A as a draft, move far enough sideways and measure the same target from position B.
  2. Save draftMove to a second position and measure the second bearing.
  3. Bearing BRepeat the second bearing from another position.
  4. Calculate intersectionsSelect two objects (bearings or circles) to calculate their intersections.
  5. Save cross bearingThe result combines GPS accuracy, bearing uncertainty and the intersection angle.

Target point

Quality

The result combines GPS accuracy, bearing uncertainty and the intersection angle.

Target pointAccuracy and limits
Bearing A / Bearing BSave bearing A as a draft, move far enough sideways and measure the same target from position B.
Possible distance: … to …Range: Compass, alignment and GPS variations can shift the intersection point.
Accuracy: +/- …Compass, alignment and GPS variations can shift the intersection point.
Quality: …The result combines GPS accuracy, bearing uncertainty and the intersection angle.
Baseline: …Place at least two bearings from different locations. Clear crossing angles give more reliable results.
Intersection angle: …Flat intersection angle: accuracy may be weak.

Accuracy and limits

Quality: …

Compass, alignment and GPS variations can shift the intersection point.

Quality: …Workflow
Compass or GPS accuracy is not usable.The result combines GPS accuracy, bearing uncertainty and the intersection angle.
The bearings are nearly parallel.Flat intersection angle: accuracy may be weak.
The intersection is behind one of the bearings.Repeat the second bearing from another position.
The calculated target is too far away.Repeat the second bearing from another position.
Short baseline: move farther from point A if possible.Place at least two bearings from different locations. Clear crossing angles give more reliable results.
Large uncertainty range: verify the result before using it.Compass, alignment and GPS variations can shift the intersection point.

Tools

Calculate Intersections

Select two objects (bearings or circles) to calculate their intersections.

Select exactly two objects:

Select two objects (bearings or circles) to calculate their intersections.

Calculate intersections

Combine two or more bearings to narrow down a position. Use map bearings or LiveView bearings, then calculate and save the intersection points.

Place marker

Target point

Calculate Intersections
Place marker

Accuracy and limits

Save draft

Place at least two bearings from different locations. Clear crossing angles give more reliable results.

Minimize

Move to a second position and measure the second bearing.

Save draft

Repeat the second bearing from another position.

Discard

The current cross bearing measurement and its saved draft will be discarded.