Manual

Circle

The circle, shown as a circle in the app, marks a radius around a center point. This allows ranges, search areas, restricted areas or rough distances to be made visible directly on the map.

Overview

What a circle stores

A circle consists of center, radius, appearance and visibility. It remains as an object in the project and can be used later.

Center point

The center point can be taken directly on the map, via coordinates, from existing objects or from your GPS position.

radius

The radius describes the distance from the center to the edge of the circle. The current value is displayed in the tools menu near the circle.

Further use

Circles can be edited, shown or hidden, exported, shared, used for search grids, or intersected with bearings in the Object Browser.

Steps

Create a circle

The normal process is: start the tool, set the radius and select the center.

  1. Step 1Open the Tools menu at the bottom and select Circle.
  2. Step 2Check or adjust the radius in the lower tool bar.
  3. Step 3Select center point: Tap map, enter coordinates, select object or use here (GPS).
  4. Step 4The circle is saved on the map and then opened as an object or managed in the object browser.
  5. Step 5If necessary, edit the name, visibility, color, fill, transparency or radius.

Select point

Options for the centre point

The center determines where the radius lies on the map.

OptionDescription
Tap mapTap the map in the circle tool. The tapped position is used as the center of the circle.
🌐 CoordinatesOpens the coordinate input. Suitable if the center point is available as an exact coordinate.
📋 ObjectsOpens the object browser. An existing object can be adopted as the center point.
⌖ Here (GPS)Sets the center point to your current GPS position. A location must be available for this.

Options

Radius, representation and further use

The circle is a normal map object and can be used after it has been created.

OptionDescription
radiusYou set the radius in the lower tool bar. The app adopts the value when setting the circle; Valid values are from 1 m to 100 km.
DepictionThe circle is saved with border, fill, color, transparency and visibility. You can edit these properties later on the object.
Search gridA circle can serve as the basis for a search grid. This is practical if you want to work through a radius systematically.
intersectionCircles can intersect bearings or other circles. You can create markers at the resulting intersection points.

Intersection points

Intersect a circle with a bearing or another circle

Select two suitable objects in the object browser and calculate their intersections. The app supports bearing + circle, circle + circle and bearing + bearing.

Bearing + radius

Shows where a direction line enters or exits the radius. Depending on the relative position, there are 0, 1 or 2 intersection points.

Circle + circle

Shows the intersections of two circles. This helps narrow down a location when two distances are known.

Set markers

Intersection points found can be directly adopted as markers. They can then be edited or shared like other markers.

Related

Matching pages

The radius, bearing and search grid complement each other when working in the field.

Tools menu Bearing Areas Quick start